Why is my Steba Food Saver not working?
If your Steba Food Saver isn't working, there could be a few reasons. First, check the fuse to ensure it hasn't blown. Another possibility is that the door isn't fully closed. Also, make sure the device is properly plugged in.
What to do if Steba KVK 50 bag is not tight?
If the bag isn't tight after using your Steba Food Saver, there might be a few reasons: * Avoid vacuuming sharp objects, as they can pierce the bag. * Ensure the bag is hooked in without any creases. * Keep both the bag and the sealing bar clean to ensure a proper seal. Be careful, as the sealing bar may be hot and pose a burn risk.
Why does my Steba Food Saver stop working after vacuuming for a while?
If your Steba Food Saver stops working after some use, it might be overheating. To prevent this, allow about 20 seconds of pause between each vacuuming operation. If the temperature fuse 'E' lights up on the display, switch off the appliance and let it cool down for about 10 minutes before using it again.
What to do if Steba Food Saver E 01 unit sucks for a while?
If your Steba Food Saver displays 'E 01' and the unit sucks for a while, ensure that the door is properly locked. Also, check and fasten the gasket to make sure it's tight.
What does E 02 mean on my Steba Food Saver?
If your Steba Food Saver displays 'E 02', it indicates that the microswitch is not closed in the sealing mode. Make sure to lock the door properly.
General| Brand | Steba |
|---|---|
| Model | KVK 50 |
| Category | Food Saver |
| Language | English |
To Next Page