19
clean in warm soapy water and leave to dry.
∙ Wipe the other parts with a damp cloth with detergent and
dry.
∙ Do not use abrasive detergents or wire wool.
∙ Take care not to damage the upper sealing strip and up-
per seal.
∙ Make sure that no liquids get into the vacuum extraction dur-
ing cleaning.
Workplace
Important:
Never place this device on or next to hot surfaces (e.g. hot sto-
ves). Only use it on a even, stable and a heat resisting surface. It is
important that no inflammable items are near to the device. Do
not place the device on the edge of the table so that it cannot be
touched by children or fall down when touched.
Wall Mounting
Drill holes in the wall according to the drilling template. Make
sure that no flush-mounted cables are damaged. Insert the do-
wels and mount the screws at a distance of 3 - 4 mm between the
wall and the screw head. Suspend the device with the suspension
holes in the back wall.
Before initial use:
∙ Wipe off the device with a damp towel.
∙ Click the sealing strip into place and insert the drip tray.
∙ The sealing rings and the bag sealing bar must be clean and level, otherwise it will
not be possible to generate a vacuum.
Film bags
Use only the special plastic bags that are suitable for vacuuming and sealing. If the
wrong film is used it will stick to the device and damage the sealing bar. The follow-
ing special films are available from Steba, among other things:
Please visit our homepage to get an overview about our current assortment of vacu-
um film rolls and bags.
To Next Page
Loading...