BASIC
Steca Solsum F
6.6F, 8.8F, 10.10F
The Steca Solsum F-Line continues the huge success of one of the
most used SHS controllers. With a power range of up to 10 A at
automatically recognized 12 V or 24 V it fits to a system sizes of
maximum 240 W.
The circuit board is completely electronically protected and with
the LED user interface it is easy to check the battery state of charge
at any time. Large terminals guarantee a simple connection of solar
panels, battery and load. The Steca Solsum F works on PWM as a
low loss series controller.
Product features
∙ Series controller
∙ Voltage regulation
∙ Automatic detection of voltage
∙ PWM control
∙ Multistage charging technology
∙ Current compensated load disconnection
∙ Automatic load reconnection
∙ Temperature compensation
∙ Common positive grounding or negative grounding on
one terminal
∙ Monthly maintenance charge
Electronic protection functions
∙ Overcharge protection
∙ Deep discharge protection
∙ Reverse polarity protection of module, load and battery
∙ Automatic electronic fuse
∙ Short circuit protection of load and module
∙ Overvoltage protection at module input
∙ Open circuit protection without battery
∙ Reverse current protection at night
∙ Overtemperature and overload protection
∙ Battery overvoltage shutdown
Displays
∙ Multifunction LED display
∙ Multi-coloured LED
∙ 4 LEDs show operating states
~ for operation, state of charge, fault messages
Options
∙ Night light function pre-set in the factory or adjustable
via Steca PA RC 100
∙ Parameterisation of function values via Steca PA RC 100
Certificates
∙ Compliant with European Standards (CE)
∙ RoHS compliant
∙ Developed in Germany
∙ Manufactured according to ISO 9001 and ISO 14001
6.6F 8.8F 10.10F
Characterisation of the operating performance
System voltage 12 V (24 V)
Own consumption < 4 mA
DC input side
Open circuit voltage solar module < 47 V
Module current 6 A 8 A 10 A
DC output side
Load current 6 A 8 A 10 A
End of charge voltage 13.9 V (27.8 V)
Boost charge voltage 14.4 V (28.8 V)
Reconnection voltage (LVR) 12.4 V … 12.7 V
(24.8 V … 25.4 V)
Deep discharge protection (LVD) 11.2 V … 11.6 V
(22.4 V … 23.2 V)
Operating conditions
Ambient temperature -25 °C … +50 °C
Fitting and construction
Set battery type gel (adjustable via Steca PA RC100)
Terminal (fine / single wire) 4 mm
2
/ 6 mm
2
- AWG 12 / 9
Degree of protection IP 32
Dimensions (X x Y x Z) 145 x 100 x 30 mm
Weight approx. 150 g
Technical data at 25 °C / 77 °F
SOLAR CHARGE CONTROLLERS
Areas of application:
240 W
To Next Page
Need help?
General
