Steca TR-A501T-U - Setting the Time; Setting the System; Setting the Functions; Setting the Parameters

23
742.110 | 14.50
EN
9.3 Setting the time
Note
The time must be once more set to the correct values if power is removed for
a longer period of time. After this, the same operating mode is displayed as was active
previous to the removal of power.
√ flashes.
1. Press SET. The hours display flashes.
2. Press  to change the hour.
3. Press SET. The minute flashes.
4. Press  to change the minute.
5. Press SET. The change is adopted.
9.4 Setting the system
Note
The systems are described in section 4.4, p. 10.
√
Syst
flashes.
1. Press SET. The number of the current system flashes.
2. Press  to select a different system.
3. Press SET. The change is adopted.
9.5 Setting the functions
√
F
unc
flashes.
X Continue as described in section 10.
9.6 Setting the parameters
Note
Details on the parameters are provided in section 11, p. 39.
√
P
ara
flashes.
1. Press SET. P:01 (Parameter number) flashes.
2. Press  to display a different parameter.
3. Press SET. The value of the parameter is displayed, associated components flash in
the system graphics.
4. Press SET. The parameter value flashes.
5. Press  to change the value.
6. Press SET to adopt the change.
7. Press ESC. The parameter number is displayed (flashing).
8. If necessary, repeat steps 2 – 7.
9.7 Resetting to factory settings
√ flashes, RESEt is displayed (RE and SEt alternately).
1. Press and hold SET for 5 seconds.
2. A progress display is shown for a few seconds. After this the reset is finished.
3. Continue as described in section 5, p. 11.