Steelcase DOUBLE PEDESTAL DESK User Manual

Steelcase, Inc.
Grand Rapids, MI 49501
U.S.A.
1-888-783-3522
Y9501946
Rev. G
Assembly Directions
Tools
Printed in the U.S.A.
1/8"
(3.1 mm)
IMPACT - Attaching Pedestal, End Panel
and Center Kneespace Panel to Worksurface
DOUBLE PEDESTAL DESK
(showing slip fit)
LH SINGLE PEDESTAL DESK
(shown in this direction)
FULL STORAGE CREDENZA
LH KNEESPACE CREDENZA
w/ CENTER SUPPORT PANEL

Steelcase DOUBLE PEDESTAL DESK Specifications

General

Brand	Steelcase
Model	DOUBLE PEDESTAL DESK
Category	Indoor Furnishing
Language	English

Summary

Attach a Pedestal to a Worksurface

Determine Pedestal Placement and Align Brackets

Locate pedestal position and align mounting brackets with worksurface routs for secure attachment.

Secure Brackets to Worksurface

Fasten each bracket to the worksurface using the specified screws into pre-drilled holes or routs.

Attach an End Panel to a Worksurface

Prepare End Panel with L-Brackets

Fit and attach L-brackets into the routed recess of the end panel using provided screws.

Assemble End Panel and Back Panel

Connect the back panel to the end panel using steel dowels and cam locks for a secure joint.

Secure End Panel Assembly to Worksurface

Attach Z-brackets to the bottom of the worksurface, aligning with the end panel assembly.

Attach a Center Support to a Worksurface

Attach Angle Brackets to Support Panel

Fasten angle brackets to the top of the center support panel using specified screws.

Position and Secure Center Support

Place the support assembly onto the worksurface, flush with the rear edge, and secure it.

Complete Pedestal and Worksurface Assembly

Prepare Pedestal Access

Remove back panel and top drawer(s) to gain access to the pedestal interior for mounting.

Mount Worksurface onto Pedestal(s)

Lower the worksurface onto the pedestal(s), ensuring brackets engage with rails.

Secure Pedestal(s) to Worksurface

Fasten the pedestal(s) to the worksurface using bolts and rectangular nuts.