Steg DSP 8 - 8 Stand Installation Reference; Channel Stand Alone Treble Mode; Channel Passive X-Over Treble Mode; Channel Separate Treble,Middle Mode

PRODUCT BRIEF INTRODUCTION
[ 17 ]
PRODUCT BRIEF INTRODUCTION
[ 18 ]
8.3 8 CHANNEL SEPARATE TREBLE,MIDDLE MODE
SubwooferSubwoofer
GroundGround
Front1/CH1+CH2 To MidrangeFront1/CH1+CH2 To Midrange
Subwoofer/CH7+CH8 To SubwooferSubwoofer/CH7+CH8 To Subwoofer
HuHu
RemRem
12+12+
++
--
ACCUACCU
RelayRelay
Rem OutRem Out
4Ch/Power4Ch/Power
Mid bassMid bass
4Ch/Power4Ch/Power
TWTW
MidrangeMidrange
Front1/CH3+CH4 To TweeterFront1/CH3+CH4 To Tweeter
Rear/CH5+CH6 To MidbassRear/CH5+CH6 To Midbass
12. X-OVER AND EQ CHARTS.
1.Red lines and slopes will change accordingly when
HP/LP of crossover and EQ are modified.
2 .EQ all frequency points can be move left or right.For 20Hz-20KHz can be any Regulation.
13. EQ SETTING.
Q volue=1-12.
8.STAND INSTALLATION REFERENCE
8.1 5 CHANNEL STAND ALONE TREBLE MODE
HuHu
++
--
Hi Level inputHi Level input
12+12+
GroundGround
AccAcc
Rem OutRem Out
Front1/CH1+CH2 To MidbassFront1/CH1+CH2 To Midbass
Front2/CH3+CH4 To TweeterFront2/CH3+CH4 To Tweeter
Subwoofer/CH7+CH8 To SubwooferSubwoofer/CH7+CH8 To Subwoofer
LTWLTW
RTWRTW
LMBLMB
RMBRMB
4 ch Amp4 ch Amp
Rem InRem In
Relay 12+Relay 12+
Rem InRem In
Monoblock/Monoblock/
2ch Amp2ch Amp
SubwooferSubwoofer
8.2 5 CHANNEL PASSIVE X-OVER TREBLE MODE
GroundGround
Front1/CH1+CH2 To Front SpeakerFront1/CH1+CH2 To Front Speaker
Front2/CH1+CH2 Or Rear CH5+CH6To Rear SpeakerFront2/CH1+CH2 Or Rear CH5+CH6To Rear Speaker
Subwoofer/CH7+CH8 To SubwooferSubwoofer/CH7+CH8 To Subwoofer
HuHu
Low Level inputLow Level input
RemRem
12+12+
++
--
ACCACC
RelayRelay
Passive X-OverPassive X-Over
4Ch4Ch
SubwooferSubwoofer
Mono/2ChMono/2Ch
Rem OutRem Out
Rear SpeakerRear Speaker
Rear SpeakerRear Speaker
Front SpeakerFront Speaker
CoaxialCoaxial