Steinbach BP-39WS-B Mini - Operation; RCD adapter and testing

Operation
CAUTION!
Risk of injury!
A damaged device or damaged accessories can lead to injuries.
- Check the device and the accessories (see the chapter on “Points
to check”).
NOTE!
Reduced or blocked
venlaon of the heat pump can lead to
insucient removal of heat or moisture. This can cause mould to
form or overheang of the nned heat exchanger.
-
Clean the grille in front of the fan blade and the ns of the heat
exchanger regularly and ensure that debris such as leaves or the
like do not enter the inner part of the heat exchanger.
-
Ensure that the grille on the heat exchanger is never covered
over and air can ow freely through the device.
RCD adapter
The RCD adapter
C
consists of an earth-contact plug and a residual current device. The
earth-contact plug must be connected to a suitable power socket with a protecve earth
conductor. The residual current device disconnects the heat pump from the electricity as
soon as any unexpected currents which are hazardous for humans ow via the heat
pump (e.g. body contact via electrically conducve parts of the housing).
Tesng the residual current device
1. Connect the RCD adapter
C
to the electrical supply that has been prepared at the
installaon site.
2. Press the RESET buon
12
.
The LED
11
lights up. The heat pump is supplied with electricity and is in the Standby
mode.
3. Press the TEST buon
13
.
The LED
11
lights up. The heat pump is disconnected from the electricity and the
Display
14
goes out.
4. Press the RESET buon
12
.
55
en