Steinbach BP-39WS-B Mini - Activating and setting the heater

The LED
11
lights up. The heat pump is supplied with electricity and is in the Standby
mode.
The residual current device of the RCD adapter has now been tested successfully.
Activating the heater
The temperature range that can be set in operang mode is 15-35°C. The standard value
of the set water temperature is 27°C.
You can heat the water in the pool fastest with maximum water ow through
the heat pump (see secon "Technical data"). However, increasing the
throughput reduces the dwell me at the heat exchanger. As a result, the
total temperature dierence between the water in the pool and the heated
water at the inlet of the pool is smaller and therefore less percepble.
Please measure and write down the change to the current water
temperature every 30 minutes to detect the actual heang of the pool
water.
Acvang operang mode
1. Press the RESET
12
buon.
The LED
11
is lit. The heat pump is being supplied with power and is in standby mode.
2. Press the ON/OFF
15
buon.
The heat pump
1
is in operang mode and the display
14
shows the current water
temperature in °C.
Seng the desired water temperature
1. Repeatedly press the Up
16
or Down
17
buon.
The display
14
shows the desired water temperature in °C.
The heat pump does not work if the set desired water temperature is below
the measured current water temperature.
Showing or setting parameters
The heat pump has 10 parameters that can be shown or set via the display
D
(see
"Parameters").
Show parameter
1. Press and hold the SET buon
18
for 5 seconds while the heat pump is in operang
mode.
The display
14
shows "A".
2. Repeatedly press the Up buon
16
or the Down buon
17
.
56