Steinbach BP-39WS-B Mini - Deinstallation; Disconnecting the supply lines

The display
14
shows the desired parameter (A, C, 1-8) (see "Parameters").
3. Press the SET buon
18
to select the desired parameter.
The value of the selected parameter blinks on the display
14
.
Set parameter
1. Repeatedly press the Up buon
16
or the Down buon
17
.
The desired value of the selected parameter blinks on the display
14
.
2. Press the SET buon
18
.
The desired value of the selected parameter is set.
Deinstallation
CAUTION!
Risk of injury when moving heavy equipment!
The device is heavy! Incorrect liing or uncontrolled pping of the
device can result in injuries or damage to the device.
- Only li, carry or p the device with two people, never alone.
-
Pay aenon to maintaining proper posture (straight back,
secure foong, etc.).
- Use transport aids (e.g. pallet truck, or creeper dolly).
-
Wear protecve equipment such as safety footwear or gloves.
Disconnecting the supply lines
Disconnecng the electrical
1. Put the heat pump into the Standby mode (see the chapter on “Display”).
2. Press the RESET buon
12
.
3. Disconnect the RCD adapter
C
from the electrical supply.
The heat pump is now disconnected from the electrical supply.
Disconnecng the water lines
1. Switch o the water treatment pump.
2. Loosen the hose clamps
3
of the adapters
2
.
3. Pull the end of the hose o the adapter
2
on the inlet water connecon
7
.
When removing the end of the water hose, hold it with the opening facing upwards
to prevent uncontrolled spilling of the remaining water present in the hose.
57
en