Steinbach BP-39WS-B Mini - Cleaning and Inspection; Cleaning the heat pump; Pre-use inspection

4. Unscrew the end of the hose from the adapter
2
on the inlet water connecon
6
.
When removing the end of the water hose, hold it with the opening facing upwards
to prevent uncontrolled spilling of the remaining water present in the hose.
The water lines have been disconnected.
Cleaning
NOTE!
Improper cleaning can result in damage to the device.
- Clean the surface of the device with clear water aer every use.
-
Do not use any aggressive cleaning agents.
- Do not use any sharp or metallic objects such as knives, hard
puy knives or the like.
- Do not use any cleaning brushes.
- Do not use a high-pressure cleaner.
Cleaning the heat pump
1. Clean the housing and the grille of the fan
9
with a slightly damp cloth.
2. Clean the ns of the nned heat exchanger
10
carefully with a vacuum cleaner or
compressed air if necessary.
The ns are extremely sensive and must not be touched!
3. Remove any deposits in the drain connecon
4
so that condensaon water can
drain unimpeded.
4. Dry o the heat pump with a dry cloth.
The heat pump is now clean.
Inspection
Check the following before every use:
- Is there evidence of damage to the device?
- Is there evidence of damage to the controls?
- Are the accessories in proper condion?
- Are the supply lines and wiring in proper condion?
- Are the venlaon openings free and clean?
Do not put a damaged device or accessory into operaon. Have it inspected and repaired
by the manufacturer, the manufacturer’s customer service or a qualied specialist.
58