Steinbach Poolrunner - Troubleshooting

8. Separate the top and the boom part of
the lter unit.
9. Thoroughly rinse the boom part and
the top part with the lter bag with
plain tap water.
10. Connect the top and the boom part of
the lter unit and close all latches.
11. Rinse the device and the oang cable
aer each use with plain tap water
inside and out.
The device is clean.
Storage
1. Thoroughly clean the device (see secon "Cleaning").
2. Let all parts dry completely.
3. Then store the device and its accessories in a dry and frost-free place (≥ +5 °C)
without direct sunlight.
Troubleshooting
Fault
descripon Cause Remedy
The cable is twisted or tangled. The device turns in the water
during cleaning (this is
normal).
Switch o the device,
disconnect the cable and
untangle it.
There are obstacles in the
pool.
Remove the obstacles.
The cable in the water is too
long.
Pull the excess cable length out
of the water. The cable in the
water should only be long
enough so that the device can
reach all spots in the pool.
19
20
45