Steinberg UR12 - Recording and Playback Procedures; Start, Stop, and Playback Recording; Non-Cubase DAW Recording;Playback

Using the UR12
UR12 Operation Manual 12
10. Click [●] to start the recording.
11. After finishing the recording, click [■] to
stop recording.
12. Click the Ruler to move the project cursor to
the desired point for starting playback.
13. Click [ ▶ ] to check the recorded sound.
When listening to the sound over monitor speakers,
adjust the output signal level by the [OUTPUT] knob on
the device.
The recording and playback operations are now complete.
For more detailed instructions on using Cubase series
programs, refer to the PDF manual, available from [Help] in
the Cubase series menu.
Programs other than Cubase Series
1. LaunchtheDAWsoftware.
2. Turn on (O) the [DIRECT MONITOR] switch
on the front panel.
3. Adjust the input signal level of the
microphone or guitar with the [INPUT GAIN]
knob on the device.
If you have a microphone connected to the [MIC] jack,
adjust the [INPUT 1 GAIN] knob. If you have a guitar
connected to the [HI-Z] jack, adjust the [INPUT 2 GAIN]
knob.
4. While singing into the microphone or
playing the guitar, adjust the output signal
level of the headphones by the [OUTPUT]
knob on the device.
5. Start recording on your DAW software.
6. After finishing recording, stop it.
7. Playback the newly recorded sound to
check it.
The recording and playback operations are now complete.
For more detailed instructions on using the DAW software,
refer to your particular DAW’s software manual.
HINT
Setting optimum recording levels
Adjust the gain knobs so that the [PEAK] indicator
flashes briefly at the loudest input volume.