Troubleshooting
UR242 Operation Manual
26
For the latest support information, refer to the Steinberg Website below.
http://www.steinberg.net/
Unusual sound (noise,
interruption, or distortion)
Is the buffer size set too low?
Increase the buffer size compared to the current settings; refer to the section
“Yamaha Steinberg USB Driver” (page 6) for instructions.
Does your computer satisfy the system requirements?
Confirm the system requirements. For the latest information, see the Steinberg
web site below.
http://www.steinberg.net/
Are you recording or playing long continuous sections of audio?
The audio data processing capabilities of your computer will depend on a number
of factors including CPU speed and access to external devices. Reduce the audio
tracks and check the sound again.
Is a network adaptor for wired/wireless LAN running?
Disable the suspected network adaptor. Some network adaptors can cause
noise.
Is the Loopback function set properly?
Set Enable Loopback to off when not using the Loopback function. Refer to the
section “dspMixFx UR242 Setup Window” (page 11) or “Hardware Setup Window”
(page 15) for instructions.
Is the Monitor speaker switch turned on?
Confirm that the monitor speaker switch is turned on.
Is the [Pad] switch function set properly?
Turn the [Pad] switch on when connecting sensitive microphone or line devices to
the [MIC/LINE 1/2] jacks.
To Next Page
Loading...
