STEINEL HF 3360 - About this Document; General Safety Precautions

21
GB
GB
1� About this document
– Please read carefully and keep in a safe place.
– Under copyright. Reproduction either in whole or in part only with our consent.
– Subject to change in the interest of technical progress.
Symbols
!
Hazard warning!
...
Reference to other information in the document�
2� General safety precautions
Disconnect the power supply before attempting any work on the sensor�
• During installation, the electric power cable to be connected must not be live.
Therefore, switch o the power first and use a voltage tester to make sure the
wiring is o-circuit.
• Installing the sensor involves work on the mains power supply. This work must
therefore be carried out professionally in accordance with national wiring reg-
ulations and electrical operating conditions. (DE-VDE0100, AT-ÖVE-EN1,
CH -SEV1000)
3� HF3360
Proper use
– Sensor suitable for indoor wall and ceiling-mounting
The HF3360 is an active motion detector. It responds to the slightest movement
regardless of temperature. The integrated HF sensor emits high-frequency electro-
magnetic waves (5.8 GHz) and receives their echo. In response to the slightest
movement in the detection zone, the change in echo is perceived by the sensor.
A microprocessor then issues the switch command "switch light ON".
Detection is possible through doors, panes of glass or thin walls.
Optionally, all function settings can be made via the RC 5, RC 8 remote controls as
well as the Smart Remote. (➔ "7� Accessories")
Package contents for concealed installation (Fig� 3�1)
Package contents for surface-mounted installation (Fig� 3�2)
!