- 27 -
The master/slave configuration
permits detection of movement
in large-type rooms or spaces (load
connected = master, no load =
slave). The level of brightness pre-
vailing in the
room is only evaluat-
ed at the master . The slaves report
movements detected to the mas-
ter. Lighting or HVAC is switched
'ON' and 'OFF' by the master only.
Master/slave
A parallel-connected configuration
also permits the use of several
masters. In this case, each master
operates the lighting group in ac-
cordance with the level of bright-
n
ess it measures. Delay times and
brightness thresholds are selected
at each master as required. The
switched load is spread among the
individual masters. Presence is still
dete
cted collectively by all detec-
tors. The presence output can be
picked off from any master .
Master/master
Remote control
Using the r emote control, func-
tions can be conveniently activat-
ed from the floor.
Note: The pulse mode cannot be
overridden by the remote control.
Switch pulse mode 'OFF' manually.
Prese
nce Control remote contr ol
unit: EAN no.: 4007841 000387
Parallel-connected configurations
Two detectors linked with
an external stairwell lighting
timer
Old building /
building modernisation
External light source activated by
button. No twilight mode, day
mode
only.
Detector as stairwell
lighting timer
14.1
14.2
14.3
14.4
When using several det ectors,
they must be connected to the
same phase!
It is possible to operate as many
as 10 sensors.
DIM detector
14.5
GB
To Next Page
Loading...
Need help?
General
