6932200010
20
change the spare parts.
Inspect the electrode: if the centre of the electrode
has a cavity deeper than 1.5 mm, change it.
No particular tools are needed to change the torch
parts. Just unscrew the closing cap and all the
torch components can be easily replaced. When
you unscrew the cap you hear a slight click due to
a micro switch which disables the machine so as to
avoid accidental starts. Once the torch is in order,
to start work again you must press the RESET
button.
DISPOSAL OF ELECTRICAL
AND ELECTRONIC
EQUIPMENT
Do not dispose of electrical
equipment together with normal
waste! In observance of European
Directive 2002/96/EC on Waste
Electrical and Electronic Equipment
and its implementation in
accordance with national law,
electrical equipment that has reached the end of its
life must be collected separately and returned to
an environmentally compatible recycling facility. As
the owner of the equipment, you should get
information on approved collection systems from
our local representative. By applying this European
Directive you will improve the environment and
human health!
IN CASE OF MALFUNCTIONS, REQUEST
ASSISTANCE FROM QUALIFIED PERSONNEL.
DUTY CYCLE AND
EXCESSES TEMPERATURE
The duty cycle is the percentage of use of the
welding machine in 10 minutes which the operator
must respect to avoid the power supply output
blocking due to temperature exceed.
If the machine goes into excess temperature:
- The yellow led goes lit.
- It is necessary to wait about 10
minutes before resuming welding.
To Next Page
