STEMME S6 Maintenance Manual

MAINTENANCE MANUAL
STEMME TSA-M
MAINTENANCE MANUAL
STEMME TSA-M
UNSCHEDULED MAINTENANCE CHECKS
1. General
A. Special checks are to be carried out only in circumstances, outside routine inspections, where
event have occurred that may have caused damage to the aircraft or an impairment of
airworthiness possibly during the operation of the aircraft.
Furthermore, the 25-hour inspection necessary for a newly delivered aircraft and its engine, as
well as for overhauled engines and after extensive airframe repairs, falls under the special checks
since it must only be carried out once after the first 25 hours of operation of the aircraft.
2. Special Checks
A. 25-Hour Inspection
After the first 25 hours of operation an inspection within the specifications of a 100-hour
inspection is to be completed (Refer to 05-20-00).
B. Hard Landing Concerning the Landing Gear and Tail Boom
After an excessively hard landing or other unusual loads of the landing gear a thorough inspection
of the affected components and their attachment is required. Even if no obvious defects are
detectable, a visual inspection must be carried out. Examination contains parts of 100 hours
inspection listed in the STEMME S6 Inspection Time Intervals Chart (Refer to section "Scheduled
Maintenance Checks" of this chapter) concerning the landing gear.
C. Engine Fire
After an engine fire perform the following steps:
WARNING: IF SUSPECTED THAT PARTS OF THE STRUCTURE OR OF THE COWLING
WOULD BE ABLE TO HAVE BEEN DAMAGED BY THE HIGH TEMPERATURES
(DETECTABLY AMONG OTHER THINGS BY BLISTERING ON THE
PROTECTIVE COATING), ALWAYS THE MANUFACTURER SHOULD BE
CONTACTED FOR THE APPRAISAL OF THE DEFECTS BEFORE THE
AIRCRAFT IS PUT INTO OPERATION AGAIN.
(1) Disconnect battery (refer to 24-30-00).
(2) Remove engine cowling (refer to 72-10-00).
(3) Examine engine cowling. Check for signs of fire damage.
(4) Examine electrical cables for damaged insulation.
(5) Examine fuel lines for damage of the fire-protection sleeves.
(6) Check oil lines for damage of the fire-protection sleeves.
(7) Check air filter element for fire damage.
(8) Examine engine mount and shock mounts for any fire damage.
(9) Check all other hoses and pipes, as well as all gaskets and seals for fire damage.
05-50-00
Page 201
Nov 18/11

STEMME S6 Specifications

General

Brand	STEMME
Model	S6
Category	Aircrafts
Language	English