Stenner Pumps ECON FP E20PHH - Install Suction Weight to Suction Line; Do Not Mix Additives in Container; Suction Tubing Blockage Warning

26
www.stenner.comEcon FP
INSTALLATION continued
INSTALL SUCTION WEIGHT TO SUCTION LINE
1. Drill a hole into the bung cap or solution tank lid. Slide the tubing through and
secure the weighted strainer to the line.
2. To attach the strainer, push approximately 3.5" of suction line through the cap on the
strainer body. Pull tubing to make sure it is secure.
3. Suspend slightly above tank bottom to reduce the chance of sediment pickup.
DO NOT mix additives in the solution container. Follow recommended mixing
procedures according to the manufacturer.
DO NOT operate pump unless additive is completely in solution. Turn pump off
when replenishing solution.
DO NOT slide tubing all the way to the bottom of the weighted strainer. Tubing
could become flush with the nose of the strainer and the pump may not prime
due to blockage.
3"
Suction Line
3.5"
(9 cm)
Weighted
Suction Line
Strainer