Need help?Do you have a question about the Stenner Pumps E20MH and is the answer not in the manual?
General| Model | E20MH |
|---|---|
| Flow Rate | 20 GPD (Gallons Per Day) |
| Hose Material | Santoprene |
| Roller Material | Delrin |
| Tubing Material | Santoprene |
| Dimensions | 9.5" x 5.5" x 6" |
Details of Stenner Pump Company's one-year warranty, exclusions, and conditions.
Procedure for returning merchandise, including RMA number and restocking fees.
Instructions for reporting shipping damages and shortages within seven days of receipt.
Guidelines for returning pumps for warranty or repair and overhaul services.
Statement regarding the manual's purpose and Stenner's right to change products.
Lists registered trademarks used by Stenner Pump Company and their owners.
Essential safety guidelines including reading instructions, child supervision, and electrical safety.
Warnings for electrical shock, hazardous voltage, and proper grounding.
Safety guidelines for explosion, exposure risks, fire hazards, and chemical handling.
Guidelines on plumbing codes, cross connections, and general notices.
Explanation of the safety alert symbol and its meaning for injury or damage.
Lists materials for pump housings and the pump tube assembly.
Details materials for pump head rollers, tubing, ferrules, and fittings.
Specifies materials for suction line strainer, connecting nuts, and fasteners.
Lists the standard accessories included with the pump package.
Table showing pump output in ounces/milliliters per minute and pressure ratings.
Details run time in seconds for Simplex and Duplex settings at different PPG/PPL rates.
Explains abbreviations like PPG and PPL used in flow rate output charts.
Explains how the pump doses proportionally and its signal repeater function.
Describes the pump's prime cycle and operation in standby mode.
Details how to duplex two pumps for higher flow rates and achieve specific ratios.
Important safety notices for pump installation, including PPE and code compliance.
Guidelines for selecting a dry location and mounting the pump correctly.
Step-by-step instructions for connecting pump wires for simplex and duplex configurations.
Visual guide showing relay wiring for single and duplex Stennicator setups.
Visual guide showing simplex pump setup with water meter and solution tank.
Visual guide showing duplex pump setup with water meter and solution tank.
Instructions for connecting the suction and discharge lines to the pump head.
Procedure for attaching the weighted strainer to the suction line.
Instructions for connecting the discharge line to the injection point.
Steps for checking connections, flow, and fine-tuning dosing levels.
Table listing common drive assembly issues, possible causes, and solutions.
Table detailing pump head issues, causes, and corresponding solutions.
Table covering pump tube leaks, shortened life, and connection problems with solutions.
Essential safety warnings and precautions for replacing pump tubes.
Steps for preparing the pump and removing the old tube.
Procedure for installing a new pump tube and verifying operation.
Safety warnings and precautions for cleaning the injection point.
Steps to disassemble the duckbill check valve and clean the injection fitting.
Procedures for reassembling the duckbill check valve and testing.
Diagram showing the exploded view of the pump head and drive assembly components.
List of pump parts with their respective part numbers and units of measure.
A visual template for marking mounting hole positions.
Provides company address, phone numbers, fax, email, and hours of operation.
To Next Page
