19
Lubrication of linear tracks and lead screws must be carried out with supplied grease from STEPCRAFT: Klüber
Microlube GL 261 or other with similar specifications.
Apply grease on positions marked as mentioned:
1. All guide areas have to be adequately greased before the machine can be put into service
2. After 20 operating hours wipe the guide area clean and apply grease again
3. Repeat step 2 if soiled but latest every 20 hours.
Also always keep the machine clean. Any accruing chips or other soiling should be sucked off or thrown away
after each working step. Furthermore, please make sure that no chips or similar means get caught in the mobile
parts.
To Next Page
Loading...
