WARNING:
- In particular when performing setting works on the machine or the control or on the system-guided
tools, i.e. milling spindle, 3D print head, please disconnect the machine from the mains!
- Do not touch the insertion tools or motors as they can become extremely hot during use.
- Always make sure to have sufficient clearance to the mobile parts (guiding, milling cutters, shafts)
and never grasp with your hand into the machine. This may result in severe injuries!
- Never hold the work piece (in order to measure it to process it or for any other purposes) while the
machine is running. There is a high risk of injury!
- Never hold the work piece to be processed only with the hand but always firmly clamp the work
piece. Otherwise there is a high risk of injury!
Depending on the field of application of the machine (private or industrial use) please observe the correspondingly
applicable regulations for occupational safety, safety and accident prevention as well as environmental protection.
2.3 PERSONAL PROTECTIVE EQUIPMENT
WARNING: While working with the machine, wearing of safety glasses as well as safety gloves is
prescribed and necessary!
- Safety goggles (to protect the eyes against chips flying off at high speed, etc.)
- Protective gloves (to protect the hands against cuts, abrasions, etc.)
Furthermore do not wear any clothes which might get caught in the machine (ties, scarves, shawl, wide sleeves,
etc.) and do not wear any jewelry in particular no long chains and rings.
CAUTION: Milling jobs can cause a lot of noise. Wear hear protection to protect the ears against hearing
damages!
2.4 ENVIRONMENTAL CONDITIONS
The machine is only suitable to be operated inside!
NOTICE: Position the machine on a solid plane substructure in order that is stands safely and can neither slip nor
tilt over.
Make sure that there is sufficient space around the machine in order that you can work comfortably and that the
machine can fully extend to its traveling paths. Also keep sufficient clearance to possibly nearby positioned
machines.
Provide for sufficient illumination of the machine site and the working place surrounding the machine.
Place the PC which controls the machine nearby the machine so that you can have an eye on both.
All instructions for the machine and its components must be nearby.
Always avoid water exposure to all equipment not specifically designed and protected for the purpose. Moisture
causes damage to electronics.
Store the system and all components in a dry and warm environment between 18°C to 25°C, from 64°F to 77°F
respectively.
2.5 COMMISSIONING OF THE SYSTEM CONTROL AND THE SYSTEM-GUIDED TOOLS
WARNING: In order to safely and professionally commission the electronic control of the system and
possibly additionally built-in components, please imperatively read the operating instructions of the
individual components completely before the first commissioning of the whole system.
WARNING: Always check the emergency-stop switch before operating the machine (see item 2.7)
and don´t rely on the start/stop function of the control software exclusively.
Check if the individual components are perfectly connected with each other before the first commissioning and in
regular intervals later on.
To Next Page
Loading...