24
Fuel Filter Replacement (burner)
1. Close fuel shutoff valve located at the fuel tank.
2. Remove the nut securing the canister to the fuel filter body.
3. Remove the canister and the filter element.
4. Replace the element with a new one.
5. Reinstall the canister and turn on the fuel valve.
6. Attach a clear hose to the fuel pump bleeder screw on the burner and direct the hose into
a suitable container.
7. Start engine, set thermostats, then turn on the burner power switch. This will allow the fuel
pump in the burner to run so the fuel system can be bled of air.
8. Loosen the bleeder screw and observe the flow of fuel through the clear hose, when all air
is purged from the system close the bleeder screw.
9. Check entire fuel system for leaks.
10. Set the thermostats to the desired level and the burner will ignite.
Brush Inspection (Every 300 hours)
1. Using a screwdriver, remove 2 brush holders located on the exterior of the motor housing
and remove the brushes.
2. Replace brushes if less than 1/4 inch in length.
MAINTENANCE Burner
To Next Page
Loading...
