56
Watlow Series PM-12volt
Temperature Controller
Operators Programming Sequence for 12 volt devices
This programming sequence is taken from the manufacturers programming manual for this controller and con-
densed to eliminate the non-essential entries for ease of setup. Please follow the entries carefully and if any
questions arise because of misunderstanding the instructions, please call the manufacturer for clarification.
If at any time during the entries you feel that you have entered an incor-
rect entry and want to restart the procedure from the beginning, simply press
the up arrow and the down arrow at the same time to erase all entries and
begin the procedure from the beginning.
Menu Structure and Programming
The Series PM Controller has four menus that are used to determine
the configuration and operation of the controller. They are the Home Menu,
Setup Menu, Operations Menu and the Factory Menu. If you are installing
the Series PM Controller, you will need to determine the proper settings for
all menus. If the controller is already installed in the equipment that you
have purchased, you may only need to set a few of the parameters to adjust
the controller to your specific usage of the equipment. The Setup Menu dis-
plays the parameters that configure the Series PM Controller to fit your ap-
plication. When installed on new equipment, the controller is preset at the
factory prior to delivery of the equipment and is ready for operations. Al-
ways confirm that the controller is programmed correctly and operating cor-
rectly under normal operating conditions.
Caution: Pay particular attention to the h.SP setting for max. product
temperature. Do not set any higher than the product manufacturer
maximum application temperature. Do not hesitate to ask your supervi-
sor for the correct setting if any questions or concerns arise.
To Next Page
Loading...
