72
OTHER INFORMATION
Freezing Point: N/D
Melting Point: N/A
Pour Point: -48°C (-54°F)
DMSO Extract (mineral oil only), IP-346: < 3 %wt
STABILITY: Material is stable under normal conditions.
CONDITIONS TO AVOID: Excessive heat. High energy sources of ignition.
MATERIALS TO AVOID: Strong oxidizers
HAZARDOUS DECOMPOSITION PRODUCTS: Material does not decompose at ambient temperatures.
HAZARDOUS POLYMERIZATION: Will not occur.
ACUTE TOXICITY
CHRONIC/OTHER EFFECTS
Contains:
Base oil severely refined: Not carcinogenic in animal studies. Representative material passes IP-346,
Modified Ames test, and/or other screening tests. Dermal and inhalation studies showed minimal effects;
lung non-specific infiltration of immune cells, oil deposition and minimal granuloma formation. Not
sensitizing in test animals.
Additional information is available by request.
The following ingredients are cited on the lists below: None.
SECTION 10 STABILITY AND REACTIVITY
SECTION 11 TOXICOLOGICAL INFORMATION
Route of Exposure Conclusion / Remarks
Inhalation
Toxicity (Rat): LC50 > 5000 mg/
m3
Minimally Toxic. Based on assessment of the components.
Irritation: No end point data. Negligible hazard at ambient/normal handling temperatures.
Based on assessment of the components.
Ingestion
Toxicity (Rat): LD50 > 2000 mg/kg Minimally Toxic. Based on test data for structurally similar
materials.
Skin
Toxicity (Rabbit): LD50 > 2000
mg/kg
Minimally Toxic. Based on test data for structurally similar
materials.
Irritation (Rabbit): Data available. Negligible irritation to skin at ambient temperatures. Based
on assessment of the components.
Eye
Irritation (Rabbit): Data available. May cause mild, short-lasting discomfort to eyes. Based on
assessment of the components.
--REGULATORY LISTS SEARCHED--
1 = NTP CARC 3 = IARC 1 5 = IARC 2B
2 = NTP SUS 4 = IARC 2A 6 = OSHA CARC
To Next Page
Loading...
