5 — Cycle And Control Value Programming
67
Operator Manual
AMSCO® 5000 Series
10057344_H
5.3 Supervisor Mode Menus
The Supervisor mode access is secured by a password.
Supervisor Mode Menu
Supervisor mode includes the following menus:
• Cycles menu (see Section 5.4, Cycles Menu) – to copy a cycle or modify cycles.
• Transfer Cycle Reports menu (see Section 5.5, Transfer Cycle Reports Menu) – to transfer pdf reports on USB key.
• Miscellaneous menu (see Section 5.6, Miscellaneous Menu) – to enable load access code requirement to open door,
to modify drain extension time, etc.
• Change Password menu (see Section 5.7, Password Menu) – to modify supervisor password.
• Chemical Pumps Name menu (see Section 5.8, Chemical Pumps Name Menu) – to set chemical injection pump names
(14 alphanumeric characters maximum).
• Prime Chemical Pumps menu (see Section 5.9, Prime Chemical Pumps Menu) – to proceed with priming procedure.
• Units menu (see Section 5.10, Units Menu) – to set chemical injection, temperature and pressure units.
• Printer menu [if printer accessory is present; see Section 5.11, Print Menu (Accessory)] – to enable or disable printer,
to enable or disable extended printout, to print all cycles data, etc.
• Date and Time menus (see Section 5.12, Date and Time Menus) – to set current date and time of washer/disinfector.
• Language menu (see Section 5.13, Language Menu) – to set washer/disinfector operating language.
• Software Version menu (see Section 5.14, Software Version Menu) – to view information about software.
• Test menu (see Section 5.15, Test Menu) – to perform door safety test and sump safety level test.
• Cycle History menu (see Section 5.16, Cycle History Menu) – to print or save on USB key cycle or Thermal Rinse data.
Accessing Supervisor Mode
To access Supervisor mode, proceed as follows:
1. On Ready screen, press Supervisor touch pad.
2. Display requests password entry.
3. Enter supervisor password using available touch pads on keyboard screen.
4. Press OK to confirm entry. Display shows Supervisor mode screen:
To Next Page
Loading...
Need help?
General
