Need help?Do you have a question about the StetSom BRAVO Full 2000 and is the answer not in the manual?
Details connecting the positive battery terminal with a specific gauge cable and fuse.
Details connecting the negative battery terminal with a specific gauge cable.
Indicates malfunctions and protection mode activation (red LED).
Explains LED blinking patterns and corresponding causes/solutions for failures.
Lists recommended cable gauges for power, remote, and speaker connections.
Emphasizes mandatory use of fuse/breaker for protection, installed close to the battery.
Stresses that installation must be done by qualified professionals with the product OFF.
Lists checks for no power, including connections, fuses, and battery charge.
Covers potential causes for no sound, like cable issues or low level settings.
Explains PROT LED flashing, suggesting checks for vents, overheating, and shorts.
Provides steps to adjust level controls to prevent sound distortion and clipping.
Details how to make a good ground connection, remove paint, and avoid looping grounds.
Specifies the minimum output impedance for the amplifier (1 Ohm and 2 Ohms).
Lists RMS power output at different voltages (14.4V, 12.6V) and impedances.
Provides minimum input sensitivity and signal-to-noise ratio figures.
General| Signal to Noise Ratio | >90dB |
|---|---|
| Frequency Response | 10Hz - 250Hz |
| Channels | 1 |
| Maximum Power @ 12.6V @ 1Ω | 2000W |
| Operating Class | D |
| Input Impedance | 10kΩ |
| Damping Factor | 200 |
To Next Page
