94
Air Filter
All STEYR MOTORS Marine Engine models are equipped with an
air filter at the turbocharger inlet; as to specifications, see Specifica-
tions and Maintenance.
ˇ
Loosen clamp to exchange air filter. Remove air filter. Place
clamp on filter neck and mount air filter onto flange. Tighten
clamp. (3 Nm)
Maintainance Poly – V – belt resp. Serpentine Belt
FOR 4 CYL. MARINE ENGINES
˜
Occassionally check components for excessive wear and/or
clearance on tension bearing.
NOTE*): It is recommended to spray frequently some
corrosion inhibiting spray into the spring
housing of the belt tensioner.
FOR 6 CYL. MARINE ENGINES
Occassionally check components for excessive wear and/or clearance on tension bearing.
NOTE: It is recommended to spray frequently some corrosion inhibiting spray into the spring housing
of the belt tensioner
Engine alignment
Engine alignment requires special tools. The output coupler must be disengaged from the take-off shaft. This should
be rechecked during off-season storage preparations. Because of the special tools required, engine alignment is to
be performed by a STEYR MOTORS Marine dealer.
NOTE: Failure to check the engine alignment could result in premature failure of engine coupler or
universal joints.
GENERAL
and
32a
32b
*)
˜
To Next Page
Loading...