INSTALLATION
Preparations
6 | CK 20 Trend www.stiebel-eltron.com
9. Preparations
9.1 Installation site
Minimum clearances
≥10
≥100≥100
≥500
≥100 ≥100
D0000056589
!
CAUTION Injury
f Maintain the minimum clearances.
f If you are using the appliance together with a towel
rail, fit the appliance so that the towel rail is at least
600 mm above floor level.
Note
For efficient heating (without towel rail), we recommend
an installed height of between 300 and 500 mm.
Note
The dust filter is 275mm wide.
- To enable removal of the dust filter as described (see
chapter "Cleaning, care and maintenance"), maintain
a sufficiently large clearance at the side.
- If you have installed the appliance in a recess, de-
tach the appliance from the wall mounting bracket
before removing the dust filter.
10. Installation
10.1 Wall mounting
Note
Secure the wall mounting bracket with the tab cut-out
pointing upwards.
Note
Use appropriate fixing materials.
D0000056453
1
1 Wall mounting bracket
f Mark out the holes to be drilled for the wall mounting brack-
et on the wall. Use the wall mounting bracket as a template
for this purpose.
f Drill the holes.
f Secure the wall mounting bracket horizontally to the wall
with suitable rawl plugs and screws.
Note
The horizontal and vertical slots enable an adjustment in
case the fixing holes are not quite where they should be.
To Next Page
Loading...
