STIEBEL ELTRON DHB-E 18/21/24 SLi electronic - Appliance Installation Steps

INSTALLATION
Installation
ENGLISH
www.stiebel-eltron.com DHB-E SLi | 25
9.3 Appliance with adjustable connected load
The appliance DHB-E 18/21/24 SL is set to 21kW when delivered.
If the appliance is to be installed with a different output, take the
following steps:
 Plug in the coding card according to the selected output; for
selectable output and fuse protection of the appliance, see
chapter “Installation/ Specification/ Data table”.
 Tick the selected output on the type plate. Use a permanent
marker for this.
 Install the flow limiter with an output corresponding to that
of the appliance (see chapter “Installation/ Specification/
Data table”).
D0000047341
10. Installation
Standard installation
- Electrical connection from below on unfinished walls
- Water connection on unfinished walls
For further installation options, see chapter “Installation/
Installation options”:
- Electrical connection from above on unfinished walls
- Electrical connection on finished walls
- Large conductor cross-section for electrical connection from
below
- Connecting a load shedding relay
- Water installation on finished walls
- Water installation on finished walls with solder/ compres-
sion fitting
- Water installation on finished walls; fitting the appliance
cover
- Fitting the base part of the back panel with threaded fittings
on finished walls
- Wall mounting bracket when replacing an appliance
- Installation with offset tiles
- Pivoting appliance cover
- Temperature limit / Anti-scalding protection
10.1 Standard installation
Opening the appliance
26�02�02�0808
 Open the appliance by pulling the flap forwards and down-
wards, undo the screw and lift up the appliance cover.
26�02�02�1101
 Remove the back panel by pressing the two locking hooks
and pulling the base part of the back panel forwards.
Preparing the power cable
160
30
1
26�02�02�0824�
1 Installation aid
 Prepare the power cable.
Fitting the wall mounting bracket
D0000059694
 Mark out the holes for drilling using the installation template.
If the appliance is to be installed with water connections on
finished walls, also mark out a fixing hole in the lower part
of the template.
 Drill the holes and secure the wall mounting bracket at 2
points using suitable fixing materials (screws and rawl plugs
are not part of the standard delivery).
 Fit the wall mounting bracket.