STIEBEL ELTRON DHC 8 EL - Page 13

STIEBEL ELTRON
13
Installation Instruction for the qualied installer
Installation
Preparation before installation of the unit:
- Before taking any action, always
switch o the water heater’s main circuit
breaker rst.
- Place a drilling guide at the drilling
position in order to drill a hole in the wall
(Fig 7).
- Insert a wall plug and screw in (the
depth of the protruding screw head must
be correct) (Fig 7#3).
- Remove the screw from underneath
the water heater to open the cover of the
unit.
- Open the cover of the unit.
- Remove the plug connecting the
cover of the unit.
- Inspect the internal components.
The cable must be in good condition.
- Create an opening for the water
inlet in the case of wall-embeded and
wall-mounted pipes.
Fig 10 Fig 12
Fig 11
Fig 13
(concealed connection)