STIEBEL ELTRON DHC 8 EL - Page 6

STIEBEL ELTRON
6
Operation Instruction for the user and the qualied installer
2. First Operation
The water heater should rst be operated
by an expert technician only.
Before turning on the water
heater to start operation,
open all of water valves fully at
every point, so that water is able to ow
through the heater and expel air from the
pipe and the tank, until the water ow is
constant. Please ensure that the water
heater is functioning correctly, and close
the valve again.
WARNING:
When selecting an appropriate
water temperature, the temperature may
be dangerously high, especially for children.
Keep away from the hot water outlet, as it
may cause a potential scalding hazard.
- The indicator light will show.
- The DHC 8 EL Water Heater features
a temperature control knob at the front
of the unit, whereby 3 temperature levels
may be selected.
2.1 Adjusting Water Flow
If the required temperature is not
reached, you may adjust the ow rate by
turning the combination valve or water
ow control device (Fig 3, No.15).
The hot water temperature
depends on the power of the
unit, the cold water temperature and the
ow volume.