STIEBEL ELTRON IS 35 E - ELSD Testing and Operational Safety; First Operation and Handover; Service and Maintenance Notes

STIEBEL ELTRON
15
The unit is optionally equipped
with an ELSD (Type IS..E / IS...E - 2
only) It is recommended to test the
ELSD one time per month.
How to test:
Switch on the electrical supply. Press
the Test button, the Trip light will go
on. Press the Reset button.
Warning!
If the Trip light activate after
reset or if the light activate during
shower, never try to fix it. Contact
your dealer for a check and repair.
Connection wires in correct
polarity (L,N).
●
Connecting wires in wrong polarity
(L,N) causes an abnormal condition
which may lead to electric leaking,
burning, etc.
The appliance is not to be installed
in locations where freezing can
occur.
If the supply cord is damaged,
it must be replaced by the
manufacturer, its service agent or
similarly qualified persons in order to
avoid a hazard.
Material losses
Observe the max permissible
inlet temperature. Higher temperatures
may damage the appliance.
2.10 First operation
(Only to be carried out by a qualified
installer)
Before switching on, set the
rotary water valve to “Max” set-
ting until the pipework and the unit
are free of air.
- Check the operation of the water
heater.
- Before switching “ON” set the rotary
temperature to “OFF”
Handling over the unit
- Explain to the user how the unit
works and familiarize them with
its function.
- Advise users about the possible
health hazards (water tempera-
ture too high).
- Hand over this instruction manual
to the user and to be kept on a
safe place for future reference.
2.11 Service note
When carrying out any work,
isolate the unit from the mains and shut
off the water connection.
- Clean the filter
Disconnect water valve (Fig. 6 No.
17), remove filter (Fig. 6 No. 14) and
clean. Re-assemble in reverse order.
2. Operation Instruction for the user and the qualied installer