STIEBEL ELTRON SHC 2.5 Installation And Operating Instructions

7
DO NOT use this water heater with any
other voltage. Failure to use the correct
voltage may result in personal injury or
property damage.
The heater is supplied with an electrical
cable with a plug. If the cable is damaged
or length not sufficient, it must be
replaced by a licensed electrician.
ELECTRICAL DIAGRAM (SHC 2.5 & 4)
Cut-Off Thermostat Indicator
Lamp
The water heater is equipped with an
adjustable thermostat that automatically
controls water temperature. The indicator
lamp remains lit only when the water is
being heated.
The temperature is adjusted by turning
the knob clockwise (to the right) to
increase the temperature and counter-
clockwise (to the left) to decrease the
temperature.
The water heater thermostat can be set to
guard against freezing. This position
keeps the internal temperature above the
freezing point.
Freeze Protection Setting For SHC 2.5
Freeze Protection Setting For SHC 4
It is highly recommended to set the
thermostat to position “E”. Position “E” on
the thermostat represents approximately
125º F.
7. MAINTENANCE INSTRUCTIONS
Do not attempt to repair the water heater.
Call your licensed plumber or electrician
for service.
Unplug the unit whenever the water
supply is turned off.
Before calling for service, make sure that:
1. The heater is properly filled
2. The electrical supply has not been
interrupted.

STIEBEL ELTRON SHC 2.5 Specifications

General

Brand	STIEBEL ELTRON
Model	SHC 2.5
Category	Water Heater
Language	English