STIEBEL ELTRON WPE - English; 1 General Information; Intended Use; Other Symbols in this Documentation

12 | WPE
CONTENTS | INSTALLATION
General information
1. General information
This document is intended for qualied contractors.
Note
Read these instructions carefully before using the ap-
pliance and retain them for future reference.
Pass on the instructions to a new user if required.
1.1 Relevant documents
 WPM operating instructions
 WPM commissioning instructions
 WPM installation instructions
1.2 Safety instructions
1.2.1 Structure of safety instructions
KEYWORD Type of risk
Here, possible consequences are listed that may re-
sult from failure to observe the safety instructions.
 Steps to prevent the risk are listed.
1.2.2 Symbols, type of risk
Symbol Type of risk
Injury
Electrocution
1.2.3 Keywords
KEYWORD Meaning
DANGER Failure to observe this information will result in serious
injury or death.
WARNING Failure to observe this information may result in serious
injury or death.
CAUTION Failure to observe this information may result in non-se-
rious or minor injury.
1.3 Other symbols in this documentation
Note
General information is identied by the adjacent sym-
bol.
 Read these texts carefully.
Symbol Meaning
Material losses
(appliance damage, consequential losses and environ-
mental pollution)
Appliance disposal
 This symbol indicates that you have to do something. The
action you need to take is described step by step.
1.4 Units of measurement
Note
All measurements are given in mm unless stated oth-
erwise.
2. Safety
Only a qualied contractor should carry out installation, com-
missioning, maintenance and repair of the appliance.
2.1 Intended use
The appliance is intended for domestic use. It can be used safe-
ly by untrained persons. The appliance can also be used in a
INSTALLATION
1. General information ������������������������ 12
1.1 Relevant documents _________________________ 12
1.2 Safety instructions __________________________ 12
1.3 Other symbols in this documentation ___________ 12
1.4 Units of measurement _______________________ 12
2. Safety ������������������������������������ 12
2.1 Intended use _______________________________ 12
2.2 General safety instructions ____________________ 13
2.3 Instructions, standards and regulations _________ 13
2.4 Test symbols _______________________________ 13
3. Appliance description ����������������������� 13
3.1 Standard delivery ___________________________ 13
3.2 Accessories ________________________________ 13
4. Installation �������������������������������� 13
4.1 Minimum clearances _________________________ 13
4.2 Installation location _________________________ 13
4.3 Preparations _______________________________ 14
4.4 Wall mounting ______________________________ 14
5. Electrical connection ������������������������ 14
5.1 Appliance connection ________________________ 15
5.2 Connecting to the heat pump manager _________ 15
5.3 Terminal assignment _________________________ 16
5.4 Sensor installation ___________________________ 18
6. Closing the front fascia ���������������������� 18
7. Commissioning ���������������������������� 18
8. Troubleshooting ��������������������������� 19
9. Specication ������������������������������� 19
9.1 Details on energy consumption ________________ 19
9.2 Data table _________________________________ 19
GUARANTEE
ENVIRONMENT AND RECYCLING
INSTALLATION