8 | WPL 10 ACS WWW.STIEBEL-ELTRON.COM
INSTALLATION
PREPARATIONS
9.2 Mindestabstände
D0000022153
91�00�00�0036
Do not install the appliance in a recess. Two sides of the ap-
pliance must remain exposed.
Avoid installation on large, echoing floor areas (e.g. those
covered with tiles).
Avoid installation between reflective building walls. Reflect-
ing building walls can increase the sound level.
9.3 Preparation of the installation location
The substrate must be horizontal, level, solid and permanent.
Ensure that the appliance is accessible from all sides.
9.4 Handling
- You can hook lifting straps to move the appliance at the area
highlighted in grey at the bottom of the support frame.
26�03�01�1548
!
Damage to the appliance and the environment
Protect the appliance against heavy impact during trans-
port.
Only allow the appliance to be tilted during transport for a short
time to one of its longitudinal sides. The longer the appliance is
tilted, the greater the distribution of refrigerant in the system.
Wait approx. 30 minutes before starting the appliance after it has
been tilted.
9.5 Positioning
Observe chapter “Sound emissions”.
Observe the clearance dimension in the following diagram
when using a wall mounting support.
890
26�03�01�1683�
Only use weather-resistant cables.
Protect the flow and return pipes against frost with sufficient
thermal insulation. Provide thermal insulation in accordance
with applicable regulations.
Also protect all supply lines/cables against humidity, damage
and UV radiation by means of a conduit.
Note
When routing the condensate hose, observe chapter “In-
stallation / condensate drain”.
To Next Page
Loading...
