www.stiebel-eltron.com WPL 10 | 15
INSTALLATION
Fitting air hoses
Remove the backing from the adhesive tape strips on the
frame and on the plastic sheets.
26_03_01_1507
Secure the plastic sheets by pressing them onto the
appliance.
Seal gaps around the hooks with fabric tape.
13. Fitting air hoses
Note
Air hoses guide the intake air to the appliance and route
the discharge air from the appliance outdoors. They are
highly flexible, thermally insulated and self-extinguishing
in case of fire.
13.1 WPL 10 I
The air hose can be extended by turning the hose spirals into
each other. There must be an overlap of approx.30 cm. The total
length of hoses on the air intake and discharge sides must not
exceed 8m.
Never incorporate more than four 90° bends. The radius of
the bends must be at least 600mm, relative to the centre of
the hose.
Cut to size using a sharp knife. The hose spirals can be cut
with wire cutters.
Secure the air hose approx. every1m to prevent it sagging.
Manipulate the ends of the air hoses to fit the oval shape of
the connectors on the cover and the hose connection panels
or wall outlets.
26_03_01_1446
Firstly, push the outer hose slightly upwards.
26_03_01_1447
Push the inner hose halfway down the connector.
26_03_01_1448
Seal the inner hose by affixing it to the connector using the
fabric tape provided.
26_03_01_1449
Place the sealing strip provided around the connector.
To Next Page
Loading...
Need help?
General
