10 | WWK222-302 H www.stiebel-eltron.com
INSTALLATION
Safety
INSTALLATION
7. Safety
Only a qualified contractor should carry out installation, commis-
sioning, maintenance and repair of the appliance.
7.1 General safety instructions
We guarantee trouble-free function and operational reliability only
if original accessories and spare parts intended for the appliance
are used.
7.2 Instructions, standards and regulations
Note
Observe all applicable national and regional regulations
and instructions.
Take note of the appliance type plate and chapter "Specification".
8. Appliance description
The heat pump drive unit is located in the upper section of the
appliance. The DHW cylinder is located in the lower section of
the appliance.
8.1 Standard delivery
The following are delivered with the appliance:
- Condensate drain bend
- 2 straight pipe adapters G1 to G3/4 (use subject to type of
installation, see chapter "Preparations/ Siting the appliance/
Minimum clearances") comprising a flanged pipe, a gasket
and a union nut
- 2 135° pipe adapters G1 to G3/4 union nut (use subject to
type of installation, see chapter "Preparations/ Siting the ap-
pliance/ Minimum clearances")
8.2 Required accessories
Various safety assemblies are available that need to be selected
subject to the static pressure. These type-tested safety assemblies
protect the appliance against unacceptable excess pressure.
8.3 Further accessories
- Condensate pump (if the condensate cannot be drained off
with a naturally occurring fall)
8.4 Incorrect use
The following are not permitted:
- Operating the appliance when the casing is open
- Filling the appliance with a refrigerant other than the one
detailed in chapter "Specification/ Data table"
- Heating liquids other than potable water
Observe the list of requirements regarding the installation room
and non-permissible installation sites (see chapter "Installation
site").
9. Preparations
9.1 Transport
!
CAUTION Injury
Observe the weight of the appliance.
Use suitable transport aids (e.g. a pallet trolley) and
enough personnel for transportation.
!
Material losses
The appliance has a high centre of gravity and low over-
turning moment.
Safeguard the appliance against falling over.
Only set the appliance down on an even base.
!
Material losses
The appliance casing is not designed to withstand strong
forces. Incorrect handling can lead to material losses of
considerable extent.
Observe the information on the packaging.
Only remove the packaging shortly before the installation.
Where possible, do not unpack the appliance until it has arrived
in the installation room.
For transport and handling leave the appliance in its packaging
and on the pallet. This enables brief horizontal transport and pro-
vides places to hold on to during transport.
If the appliance has to be unpacked before transportation, we
recommend using a pallet trolley. Pad the contact surfaces to avoid
damaging the appliance. Secure the appliance to the pallet trolley
using a strap. Pad between the strap and the appliance and avoid
overtightening the strap. Where stair wells are narrow, you can
carry the appliance by the handles on the pallet trolley and the
foot of the appliance.
Vehicular transport
!
Material losses
The appliance must generally be stored and transported
vertically.
A transport lock fitted at the factory to the refrigerant circuit
area inside the appliance enables relatively short transportation
horizontally over a maximum distance of 160km of paved roads.
Strong shocks are not permissible.
!
Material losses
If transported horizontally, the appliance must always be
laid on the shaded side of the box.
The appliance must not remain in a horizontal position
for more than 24hours.
If the appliance was transported horizontally, leave it to
rest in a vertical position for at least one hour before
commissioning.
Observe the information on the packaging.
To Next Page
Loading...
