20 | WWK222-302 H www.stiebel-eltron.com
INSTALLATION
Maintenance
14. Maintenance
WARNING Electrocution
Prior to all work on the appliance, isolate it from the
power supply.
14.1 Removing the appliance cover
D0000040621
Undo the screw (Torx) that attaches the fascia to the
appliance.
Push the fascia upwards.
D0000040622
Carefully remove the fascia.
Undo the plug-in connection in the electrical cable that runs
to the battery pack on the back of the fascia.
Carefully lift away the appliance cover and undo the earth
cable that runs from the terminal strip to the cover.
Note
Refit the appliance cover after completing your work. See
chapter "Maintenance and cleaning/ Fitting the appliance
cover").
14.2 Removing the casing ring
Note
If you require more space to work inside the appliance,
you can remove the casing ring on the upper section of
the appliance.
D0000034803
1
1 Fixing screws on casing ring
The casing ring is fastened with screws.
Undo the fixing screws on the casing ring.
Remove the condensate drain bend and pipe collar of the
drain. Turn anti-clockwise to undo them.
!
Material losses
Inside the appliance, an earth cable is connected to the
casing ring. Undo the earth cable in order to be able to
remove the casing ring.
D0000034814
The casing ring overlaps along the joint. A tab on one end clips
into the recess at the other end of the casing ring.
Ease the casing ring apart, until it can be removed or slid
downwards.
Note
Refit the casing ring after completing the work. See chap-
ter "Maintenance and cleaning/ Fitting the casing ring").
14.3 Cleaning the evaporator
!
WARNING Injury
The evaporator consists of numerous sharp-edged fins.
Be careful when cleaning the evaporator and wear
protective clothing, especially safety gloves.
In order to maintain the appliance performance at its best, check
and clean the appliance evaporator as often as necessary.
To Next Page
Loading...
