EN - 10
13.
Intervention
Paragraph
First time
MACHINE
Check all fasteners
- Before each use 7.3
Safety checks/check controls
- Before each use 6.2
General cleaning and inspection
- At the end of each use 7.4
Check the cutting device for wear - Before each use 8.1
Check the drive belt for wear 25 hours 25 hours 8.2
14.
REMEDY
1.^>Abnormal
vibration during use
Loose parts or damaged
cutting devices
Tighten all fasteners. Get damaged
parts replaced at an authorised
after sales service centre.
The cutting means assy is full of grass. Clean the cutting means assembly
2.^>Uneven cutting
Ineciency of the cutting means Contact your local dealer
Forward speed too high in relation
to the height of the grass being cut
Reduce the forward speed and/or
raise the cutting height (par. 5.1)
Wait for the grass to dry
3.^>The cutting devices
do not engage or
do not stop quickly
when disengaged.
Problems with the engaging system
or the cutting means drive belt.
Contact an authorised assistance centre.
If problems persist after the operations above have been performed, contact your dealer.
To Next Page
Loading...
