5
Fasten the cable (16) to the cable fasteners (17) and (18)
1.2 Assembling the grass catcher
(Type“I”)
-
er, snapping it into the appropriate seats.
(Type“II”)
2. CONTROLS DESCRIPTION
NOTE
explained in the previous pages.
2.1 Dual-action switch
accidental start ups.
levers (1a) for start up.
WARNING! Ignition of the motor simultaneously
engages the cutting means.
levers (1a) are released.
2.2
DO THIS WHEN THE CUTTING MEANS IS STATIONARY.
3. GRASS CUTTING
NOTE This machine can be used to mow lawns in a num-
-
3.1a
and collection in the grass catcher (Type“I”-
“II”):
– Lift the rear discharge guard (1) and fasten the grass
3.1b
and rear discharge:
-
3.1c
and mulching (where applicable)
– Lift the rear discharge guard (1), position the chute cap
(5) inside the discharge opening and push it as far as
discharge opening.
-
3.2 Ignition
IMPORTANT When starting up the machine, there can be
-
vent disturbances to other equipment connected to the pow-
3.3 Grass cutting
-
cut.
When the grass catcher is too full, grass collection is no
– lift the rear discharge guard, grasp the handle and re-
• When mulching:
-
being cut.
Lawn care recommendations
-
3.4
-
vers (1a).
-
IMPORTANT If the motor stops while mowing due to over-
To Next Page
Loading...
