EN
ENGLISH
(Translation of the original instructions)
Pay attention when using the grass
catcher and attachments that can alter
the stability of the machine, especially
on slopes.
Do not change the engine settings or
over-rev the engine.
Do not touch the engine parts as they
get very hot when running. Burn hazard.
Disengage the cutting device or power
socket, put in neutral and engage the
parking brake, turn o the engine and
remove the ignition key (checking that
all moving parts are completely sta-
tionary):
a. Whenever the machine is left unat-
tended or the operator dismounts from
the driving seat:
b. Before clearing blockages or unclog-
ging the discharge chute;
c. Before checking, cleaning or working
on the machine;
d. After striking a foreign object. Inspect
the machine for damage and make
repairs before using it again;
Disengage the cutting device or the
power socket and switch o the engine
(making sure that all moving parts are
stationary):
a. Before refuelling;
b. Whenever you remove or reattach the
grass catcher;
c. Before adjusting the cutting height, if
this operation can not be performed
from the driving seat.
Disengage the cutting device or the
power socket during transport and
whenever it is not in use.
Reduce the throttle setting before
stopping the engine. Shut o the fuel
supply on completing the work, follow-
ing the instructions in the engine man-
ual.
Pay attention to cutting assemblies
with more than one cutting device, as a
rotating cutting device can trigger the
rotation of the others.
WARNING – If something breaks or an
accident occurs whilst working, turn
o the engine immediately and move
the machine away to prevent further
damage; if an accident occurs with
injuries or third parties are injured,
carry out the rst aid measures most
suitable for the situation immediately
and contact the medical authorities for
any necessary health care. Carefully
remove any debris which could cause
damage or injury to persons or ani-
mals if ignored.
WARNING! The noise and vibration
levels shown in these instructions
are the maximum levels for use of the
machine. The use of an unbalanced
cutting element, the excessive speed
of movement, or the absence of main-
tenance have a signicant inuence
on noise emissions and vibrations.
Consequently, it is necessary to take
preventive steps to eliminate possible
damage due to high levels of noise and
stress from vibration. Maintain the ma-
chine well, wear ear protection devic-
es, and take breaks while working.
3.4 MAINTENANCE AND STORAGE
WARNING! – Before cleaning or doing
maintenance work, take out the igni-
tion key and read the relevant instruc-
tions. Wear proper clothing and protec-
tive gloves whenever your hands are at
risk.
WARNING! – Never use the machine
with worn or damaged parts. Faulty
or worn-out parts must always be re-
placed and never repaired. Use origi-
nal replacement parts only: the use of
non-original and/or incorrectly tted
parts will jeopardize the safety of the
machine, may cause accidents or per-
sonal injuries for which the Manufac-
turer is under no circumstance liable
or responsible.
Any adjustments or maintenance op-
erations not described in this manual
must be carried out by your Dealer or
a specialized Service Centre with the
necessary knowledge and equipment
to ensure that the work is done correct-
ly maintaining the machine’s original
safety level. Any operations performed
9
To Next Page
Loading...
Need help?
General
