22
EN
ENGLISH
(Translation of the Original Instructions)
14 TROUBLESHOOTING
Problem Probable cause Remedy
1. The starter motor does not
turn.
Battery not charged enough. Recharge the at battery.
Battery not connected. Check the connections.
2. The starter motor turns but
the engine doesn't start.
With the ignition key in the
start position, the starter
motor turns but the engine
doesn't start.
Fuel cock closed. Open the fuel cock.
No fuel ow. - Check the fuel level in the tank.
- Check the fuel lter.
or engine runs irregularly.
Carburettor problems. Clean or replace the air lter.
4. Drop in engine performance
during cutting.
Forward speed too high in rela-
tion to the cutting height.
Reduce the forward speed and/
or raise the cutting height.
5. The engine stops for no
apparent reason.
- Fuel tank empty.
- Try to restart the engine.
Fill the fuel tank (if the problem
persists, contact an authorised
assistance centre).
6. Uneven cutting. Check the tyre pressure.
The cutting device sharpness
level is low.
Contact an authorised assistan-
ce centre.
Forward speed too high in
relation to the height of the grass
being cut.
Reduce the forward speed and/
or raise the cutting height.
The cutting device assy is full of
grass.
- Wait for the grass to dry.
- Clean the cutting device assy.
7. Abnormal vibration during
use.
- Unbalanced cutting devices.
- Slackened cutting devices.
- loose components.
- possible damage.
Contact an authorised assistan-
ce centre for inspection, replace-
ment or repair operations.
8. With the engine running,
activation of the traction pedal
does not move the machine.
"Disengage transmission” lever in
the disengaged position.
Engage the transmission.
If problems persist after the operations above have been performed, contact your dealer.
To Next Page
Loading...
Need help?
General
