Edition Manual Chapter Page
2008-03-18 Workshop Manual, Stiga Primo 2 Chassis and Body 4
2.3 Adjustments
2.4 Brake - Clutch
General
Pedal has the following functions:
•Clutch
• Service brake
• Parking brake
The pedal has three positions:
1. Pedal released – forward drive engaged.
The machine will move if a gear is engaged.
Service brake not activated.
2. Pedal depressed halfway – forward drive
disengaged, gear shifting can be performed.
Service brake not activated.
3. Pedal fully depressed – forward drive
disengaged. Service brake fully activated.
Also see “Parking brake” below.
4. Pedal fully depressed and locked – Parking
brake.
Adjustment
The adjustment is performed in 2 steps:
Step 1
The pedal shall have a play of 10-20 mm at the
top.
Adjust this play by inserting the cotter pin in a
suitable hole in the brake rod.
Note!
Check that the pedal return spring (A) is
in place. If not, the play cannot be felt.
10-20 mm
A
To Next Page