-
1.
2.
3.
-
5.
7.
NOTE
If the machine is used in an-
ti-freeze mode at higher temperatures, this may
cause diculties when starting the engine and
during use due to the incorrect engine speed. Al-
ways check that the machine is switched to normal
mode (with the “SUN” symbol facing upwards) if
there is no danger of ice forming.
the accelerator.
-
WARNING!
Do not use the machine if
the chain moves when the engine is running
idle; in this case, contact your dealer.
IMPORTANT
Avoid using the engine at full
power for the rst 6-8 working hours.
STOPPING THE ENGINE (Fig. 10)
WARNING!
When you have reduced
speed to a minimum, it may take a few
seconds for the chain to stop.
IMPORTANT
If the machine does not turn
o, pull the starter to ood and stop the engine and
immediately contact the dealer to nd the cause of
the problem and request necessary repairs.
USING THE ANTI-FREEZE DEVICE
(excluding C 46 - XC 246 - C 50 - CP 45
- A 455 - MC 846 models) (Fig. 11)
EN
HOW TO START - USE – STOP THE ENGINE 11
To Next Page
Loading...
