WORKSHOP MANUAL
T...102/122 - TC...102/122
Map of functional units
On assembly it is advisable to spread grease on the
shaft to facilitate the next wheel removal.
● For the front wheels: replace the shoulder washer
(2) and the exible ring (1) with the bevel facing in-
wards.
● For the rear wheels: replace the shoulder washer
(2) and the exible ring (1) with the bevel facing in-
wards and check the axial gap of the wheel on the
shaft; if it is greater than 3 mm, a spacer (3) must be
tted between the wheel hub and the shoulder wa-
sher (2).
A) Tyres
After replacing one or more tyres or the wheels, it is
al ways necessary to check the pressure and to check
the alignment of the cutting deck.
ATTENZIONE Replace distorted wheel rims
as they could impair the tyre’s hold.
B) Wheels
The wheels are held by a snap ring (1) which can be
removed with the help of a screwdriver.
NOTE If a wheel is jammed onto the shaft, use a
releasing spray, directing it around the splining hole.
Validity
General informations
The tyres used are of the “Tubeless” type and so
e ve ry repair of a hole in the tyre must be done by
a ty re specialist according to the methods used
for this type of tyre.
Related topics
[
2.3] Lifting of the machine
[
4.5] Aligning the cutting deck
Tyre pressures
Front ......................... (Tyres 13 x 5.00-6) 1,5 Bar
.............................. (Tyres 15 x 5.00-6) 1,0 Bar
Rear .......................................................... 1,2 Bar
REPLACEMENT OF TYRES AND WHEELS
CHAPTER REVISION FROM ... PAGE
6.1 0 2018 1 of 1
To Next Page
Loading...
Need help?
General
