To Next Page

To Previous Page

CAUTION:

WHEN ASSEMBLING TABLE, IT IS EXTREMELY IMPORTANT THAT THE U-

CLIPS (#22) BE TURNED AS SHOWN HERE. IF U-CLIPS ARE TURNED

INCORRECTLY, YOU WILL DO IRREPARABLE DAMAGE TO YOUR TABLE

WHEN YOU ATTEMPT TO OPEN IT TO THE PLAYING POSITION.

8. Rotate U-support (#21) that is on bottom of Table Top

until you see the screw holes in the slots of U-clips (#22).

If necessary Slide U-support (#21) side to side and back

and forth to see holes. See Figure 5 & Detail B.

9. Insert Screw (#35) through slot in U-clip (#22) and into U-support

(#21). See Figure 5 & Detail B. Thread screw all the way into U-

support until it touches the back of the tube. There should be about

3/8” of screw (#35) left sticking out. Repeat for second Screw (#35)

and U Clip (#22).

Note: To aid in assembly you can use a cordless drill and

Phillips bit for Step 9 only. Wear safety glasses.

5. Lay Table Top (#1) painted side down, on a smooth, flat surface. Use the shipping

container to protect the painted surface of table top.

6. Align the ”U” Support (#21) on Table Top (#1) as shown in Figure 5.

7. Align all four holes in each U-Clip (#22) with the four Indentations in table top.

Be sure that Slot in the Three U-Clips (#22) all face the same direction toward the

end of the table with no stripe and no Indentations. Secure U-Clips (#22) with

Screws (#5) as shown in Figure 5 & Detail A.

Note: All four holes in the U-Clip (#22) must align with four Indentations

in table top. See Detail A.

If you want to see a video on how to insert Screw (#35) go to:

http://www.escaladesports.com/customer-service/videos.html

Scan with your smartphone:

Detail A

Figure 5

Note: End with no stripe

and no Indentations.

Detail B

Slot in

U-Clip

Note: All Indentations

guides in table top are

small so look closely.

Note: Indentations in table top are small so look closely.

Stiga T8623 User Manual

Questions and Answers: