Starting-throttle position
5.
To
start the engine, hold saw firmly on the ground with
your left hand around the handlebar
(7)
and put the toe
of your right foot into the rear handle (8) and pressdown.
6. Pull out starter grip slowly with your right hand until you
feel a definite resistance and then give
it
a brisk, strong
pull.
The starter rope should not
be
pulled out more than
80 cm (30 in.) as there
is
otherwise a risk of it breaking.
Do
not allow starter rope to snap back. Hold
it
vertically
130
that
it
can rewind correctly.
7.
Once the engine
is
running, release the starting throttle
lock (6) immediately
by
briefly squeezing the trigger so
that the engine can settle down to idle speed.
8.
On Quickstop models the chain brake has to be disen-
gaged before you can start cutting - pull hand guard
(1)
back toward the handlebar
(7).
9.
The engine is stopped by flicking the stop switch (2)
20 to the
"STOP"
position.
Top: Starting
Center: Chain brake disengaged
Boltom: Stop switch in
"STOP"
position
___
7
5T1HL
To Next Page
Loading...
Need help?
General
