Stihl 350 - Mounting the Cutting Tools; Blade and Saw Blade Mounting

25FS 300, FS 350, FS 400, FS 450, FS 480
English / USA
Grass Cutting Blades,
Brush Knife
: Place the cutting tool (1) in position.
Collar (see arrow) must engage the
cutting tool’s mounting hole.
Grass cutting blade 255-8:
Cutting edges must point
clockwise.
: Fit thrust washer (2) – convex side
must face up.
: Fit rider plate (3) for mowing.
: Block the output shaft.
: Screw on nut (4) counterclockwise
and tighten it down firmly.
Removing the cutting tool
: Block the output shaft.
: Unscrew the nut clockwise.
If the mounting nut is too loose,
fit a new one.
Circular Saw Blades 200 and 225
: Place the cutting tool (1) in position.
Collar (see arrow) must engage the
cutting tool’s mounting hole.
Cutting edges must point
clockwise.
: Fit thrust washer (2) – convex side
must face up.
: Fit rider plate (5) for sawing.
: Block the output shaft.
: Screw on nut (4) counterclockwise
and tighten it down firmly.
Removing the cutting tool
: Block the output shaft.
: Unscrew the nut clockwise.
If the mounting nut is too loose,
fit a new one.
2
3
4
5
1
1
2
4
256BA068 KN