What to do if Stihl FSA 85 Brush Cutter cuts out during operation?
If your Stihl Brush Cutter cuts out during operation, it could be due to the battery or machine's electronics being too hot. Remove the battery and allow both the battery and machine to cool down. It may also be due to an electrical or electromagnetic malfunction. Try removing the battery and refitting it.
Why Stihl FSA 85 running time is too short?
If your Stihl Brush Cutter's running time is too short, it could be due to several factors. The battery may not be fully charged, so ensure you charge it completely. You might be using an unsuitable nylon line, in which case you should replace it. The useful life of the battery may also have been reached or exceeded; check the battery and replace it if necessary.
How to fix a Stihl FSA 85 battery that jams when inserting?
If the battery jams when being inserted into your Stihl Brush Cutter or charger, the guides or contacts may be dirty. Carefully clean the guides and contacts to resolve this issue.
What to do if Stihl FSA 85 battery is not charging but the LED on the charger glows green?
If your Stihl Brush Cutter battery isn't charging even though the LED on the charger glows green, the battery might be too hot or too cold. Allow the battery to cool down or warm up slowly at a temperature of about 15°C - 20°C. Operate the charger only in closed, dry rooms at ambient temperatures between +5°C and +40°C.
What does it mean when the light emitting diode on Stihl Brush Cutter charger flashes red?
A flashing red light on your Stihl Brush Cutter charger indicates a few potential issues. There may be no electrical contact between the charger and the battery, so try removing and refitting the battery. It could also indicate a fault in the battery; in that case, take the battery out of the power tool and refit it. Switch on the machine – if the LEDs continue to flash, the battery has a malfunction and must be replaced. Finally, it could signal a fault in the charger, which would require a servicing dealer to check it.
Why Stihl FSA 85 Brush Cutter won't start?
Your Stihl Brush Cutter might not start due to several reasons: * There may be no electrical contact between the power tool and the battery. You can remove the battery, visually check the contacts, and refit the battery. * The battery may have a low charge. In this case, charge the battery. * The battery might be too hot or too cold. Allow the battery to cool down or warm up slowly at a temperature of about 15°C - 20°C. * There could be a fault in the battery. Remove the battery, refit it, and switch on the machine. If the LEDs continue to flash, replace the battery. * The power tool might be too hot. Allow the power tool to cool down. * There may be an electromagnetic problem or fault in the machine. Remove and refit the battery. If the LEDs still flash, have the power tool c...
Explains symbols used in the manual for clarity.
Explains warning and notice symbols for safety and caution.
Covers safe operating practices, user responsibilities, and operating conditions.
Describes required protective clothing and personal protective equipment (PPE).
Instructions for safely carrying and transporting the tool.
Checks and preparations required before operating the tool.
Guidance on how to properly hold and control the tool.
Emergency procedures and safe operation practices during use.
Advice on challenging conditions, obstacles, and work area checks.
Guidelines for calm work, unattended tool, cutting attachment checks, and cleaning.
Information on vibrations and safety during maintenance.
Step-by-step guide on how to mow with the unit.
Explanation and use of the bump guard accessory.
Instructions for adjusting the loop handle for operator comfort.
Specifies approved cutting attachments for safety.
Specifies approved deflectors for safety.
Detailed steps for mounting the deflector.
How to advance and adjust the nylon cutting line.
Explanation of battery status LEDs.
How charging progress is indicated by LEDs.
How LEDs indicate charge status during operation.
Troubleshooting for red LED lights on the battery.
Explanation of the trigger switch and speed control.
Procedure for turning off and securing the tool.
Instructions for proper storage of the unit.
Recommendations for battery storage.
Recommendations for charger storage.
Steps for disassembling and reassembling the mowing head.
Guide on how to wind the nylon line onto the spool.
Instructions for attaching the mowing head to the tool.
Troubleshooting for charging problems and charger errors.
Specific sound power measurements for the product.
General| Battery Type | Lithium-Ion |
|---|---|
| Battery Voltage | 36 V |
| Sound Power Level | 94 dB(A) |
| Power Source | Battery |
| Cutting Tool | AutoCut C 4-2 |
| Shaft Type | Straight |
| Weight | 2.8 kg (6.2 lbs) without battery |
To Next Page
