FSA 65, FSA 85
English
35
The loop handle can be adjusted to suit
the height and reach of the operator and
the application by changing
distance (A).
Recommendation: distance (A):
about 10 cm
N Slide the handle to the required
position.
N Tighten down the star knob so that
the handle cannot be rotated on the
shaft.
N Position your trimmer so that the
mowing head (1) faces up.
The motor housing has guide slots
(arrows) to correctly locate the deflector.
N Push the deflector (2) into the guide
slots as far as stop.
N Insert the screws (3) and tighten
them down firmly.
Adjusting Nylon Line
N Hold the rotating mowing head
above the ground – tap it on the
ground once – about 3 cm fresh line
is advanced.
The blade (1) on the deflector (2) trims
surplus line to the correct length – avoid
tapping the mowing head more than
once at a time.
Line feed operates only if both lines still
have a minimum length of 2.5 cm.
If the line is shorter than 2.5 cm:
N Switch off the trimmer.
N Move the retaining latch to ƒ and
remove the battery.
N Turn the trimmer on its back.
N Press down the cap on the spool as
far as stop.
N Pull the ends of the lines out of the
spool.
If the spool is empty, see "Replacing
Nylon Line".
Mounting the Deflector
Adjusting Nylon Line
To Next Page
Loading...
